4/9/2023 0 Comments Blink board or blink lite![]() It won't damage the battery, but it can be inconvenient. If the board has been fully discharged and then stored for a period of time, the natural slow lithium battery discharge can cause the battery to need to be recovered this way. If not lets get your board working again by sending it in.Īs a reminder to everyone, be sure to store your board fully charged. Let me know if you are able to get the battery to recover. Loosen the wing nut holding up the photo eye and adjust them until both sensors are properly aligned. Check the gas valves for any leaks and use caution. The machine has a fan intended to lower the temperature when overheating occurs. To remedy this, allow for the furnace to cool down. The most common cause for this is a leaky gas valve. To fix this issue, first, locate the two photo eyes attached to your garage door and clean the lens using a soft microfiber cloth. A York furnace will blink red once when no power is provided to the gas valve, and a fire is still present. If after a couple attempts you try this and it doesn't begin to charge normally (check the remote to see if it is actually gaining charge after 15min on the charger again, then you can send it to us to give it a jump start and get the battery charged again. The light from the opener blinks 10 times to warn you about misaligned photo eyes. I've even seen someone use a treadmill or a hand drill setup to get the wheels spinning for a while. This can be done by kicking the board around for 15-20 min at about 10mph, or even being creative and having someone pull you around with a bike. You just need to have the wheels spinning enough to give it just a small regenerative charge. Does the board turn on? Are there any flashing red error lights on the board? There is a possibility that the board may have been discharged too far.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |